Modeling the postural disturbances caused by upper extremity movements

This paper describes the design, validation, and application of a dynamic, three-dimensional (3-D) model of the upper extremity for the purpose of estimating postural disturbances generated by movements of the arms. The model consists of two links representing the upper and lower arms, with the shoulder and elbow modeled as gimbal joints to allow three rotational degrees of freedom. With individualized segment inertial parameters based on anthropometric measurements, the model performs inverse dynamic analysis of recorded arm movements to calculate reaction forces and moments acting on the body at the shoulder in three dimensions. The method was validated by comparing the output of the model to estimates obtained from ground reaction loads during stereotypical and free form unilateral movements at various velocities and with different loads carried by human subjects while seated on biomechanical force platforms. The correlation between predicted and measured reaction forces and moments was very good under all conditions and across all subjects, with average rms errors less than 8% of measured peak-to-peak values. The model was then applied to bimanual activities representative of functional movements that would typically be performed while standing at a counter. The resulting estimates were consistent and adequate for the purpose of evaluating postural disturbances caused by upper extremity movements.