DocumentCode :
1587257
Title :
High temperature stable WSix ohmic contacts on GaN
Author :
Pearton, S.J. ; Donovan, S.M. ; Abernathy, C.R. ; Ren, F. ; Zolper, J.C. ; Cole, M.W. ; Zeitouny, A. ; Eizenberg ; Shul, R.J.
Author_Institution :
Dept. of Mater. Sci. & Eng., Florida Univ., Gainesville, FL, USA
fYear :
1998
Firstpage :
296
Lastpage :
300
Abstract :
We have sputter-deposited 500-1200 Å thick WSi0.45 metallization onto n+ GaN (n⩾1019 cm-3) doped either during MOCVD growth or by direct Si + ion implantation (5×1015 cm-2, 100 keV) activated by RTA at 1100°C for 30 secs. In the epi samples Rc values of ~10-14 Ω cm2 were obtained, and were stable to ~1000°C. The annealing treatments up to 600°C had little effect on the WSix/GaN interface, but the β-W2N phase formed between 700-800°C, concomitant with a strong reduction (approximately a factor of 2) in near-surface crystalline defects in the GaN. Spiking of the metallization down the threading and misfit dislocations was observed at 800°C, extending >5000 Å in some cases. This can create junction shorting in bipolar or thyristor devices, Rc values of <10-6 Ωcm2 were obtained on the implanted samples for 950°C annealing, with values of after 1050°C anneals. The lower Rc values compared to epi samples appear to be a result of the higher peak doping achieved, ~5×1020 cm-3. We observed wide spreads in R c values over a wafer surface, with the values on 950°C annealed material ranging from 10-7 to 10-4 Ω cm2. There appear to be highly nonuniform doping regions in the GaN, perhaps associated with the high defect density (10 10 cm-2) in heteroepitaxial material, and this may contribute to the variations observed. We also believe that near-surface stoichiometry is variable in much of the GaN currently produced due to the relative ease of preferential N2 loss and the common use of HT containing growth (and cool-down) ambients. Finally the ohmic contact behavior of WSix on abrupt and graded composition In xAl1-xN layers has been studied as a function of growth temperature, InN mole fraction x=0.5-1) and post WSix deposition annealing treatment. Rc values in the range 10-3-10-5 Ω cm2 are obtained for auto-doped n+ alloys, with the n-type background being little affected by growth conditions (n~1020 cm-3). InN is the least temperature-stable alloy (⩽700°C), and WSix contact morphology is found to depend strongly on the epi growth conditions
Keywords :
III-V semiconductors; contact resistance; dislocations; gallium compounds; high-temperature electronics; metallisation; ohmic contacts; rapid thermal annealing; semiconductor epitaxial layers; sputtered coatings; thermal stability; tungsten compounds; 600 to 1100 C; GaN epilayer; MOCVD growth; RTA; WSi0.45-GaN; WSix ohmic contact; annealing; contact resistance; crystalline defect density; doping; heteroepitaxial material; high temperature stability; interfacial phase formation; ion implantation; metallization; misfit dislocation; sputter deposited film; stoichiometry; threading dislocation; Annealing; Crystallization; Doping; Gallium nitride; Ion implantation; MOCVD; Metallization; Surface morphology; Temperature; Thyristors;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
High Temperature Electronics Conference, 1998. HITEC. 1998 Fourth International
Conference_Location :
Albuquerque, NM
Print_ISBN :
0-7803-4540-1
Type :
conf
DOI :
10.1109/HITEC.1998.676807
Filename :
676807
Link To Document :
بازگشت