DocumentCode
1616124
Title
A microwave oscillator S -parameter design procedure for loop oscillators
Author
Weber, R.J. ; Huisinga, R. ; Ripley, D.
Author_Institution
Dept. of Electr. Eng. & Comput. Eng., Iowa State Univ., Ames, IA, USA
fYear
1992
Firstpage
1341
Abstract
A design sequence for a maximum power output loop oscillator using a surface acoustic wave (SAW) resonator at 303.5 MHz is described. The loop oscillator design technique provides a non-iterative solution for the circuit parameters and presents an optimum load or source to the active device under consideration. A block diagram of the loop oscillator and the design criteria are shown. Data relating to the performance of the oscillator are presented
Keywords
S-parameters; crystal resonators; feedback; microwave oscillators; network synthesis; solid-state microwave circuits; surface acoustic wave devices; 303.5 MHz; S-parameter design procedure; circuit parameters; design criteria; loop oscillators; maximum power output; microwave oscillator; optimum load; surface acoustic wave; Buildings; Circuits; Equations; Impedance matching; Iterative methods; Load flow; Microwave oscillators; Noise figure; Phase shifters; Scattering parameters;
fLanguage
English
Publisher
ieee
Conference_Titel
Circuits and Systems, 1992., Proceedings of the 35th Midwest Symposium on
Conference_Location
Washington, DC
Print_ISBN
0-7803-0510-8
Type
conf
DOI
10.1109/MWSCAS.1992.271092
Filename
271092
Link To Document