DocumentCode
1831507
Title
Notice of Retraction
The principle of “conjugate offset surfaces” and its application in 5-axis end milling machining of sculptured surfaces
Author
Liu Huran
Author_Institution
Dept. Mech. Eng., Zhejiang Univ Sci. & Technol., Hangzhou, China
Volume
2
fYear
2010
fDate
1-3 Aug. 2010
Abstract
Notice of Retraction
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
This paper researched how to substitute the cylindrical cutter with a circular cutter in the machining of the sculptured surface. The principle of the “conjugate offset surfaces of equal distance” has been applied into this field. First, suppose that there is a surface of second order, the coefficients of which are arbitrary. Then find out the best posture of the circle in order that the circle and the surface will most closely contact with each other at the origin position. Finally, develop the surface into a 3-order surface at every point of machining and employ the results mentioned above to find the best cutter posture at every point of machining. Therefore, the equations are easy to solve and clear in concept. This paper showed how to use this method for the machining of a die. This project is supposed by the natural scientific foundation of Zhejiang province, China, No. Y106047 and Y1080093.3.
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
This paper researched how to substitute the cylindrical cutter with a circular cutter in the machining of the sculptured surface. The principle of the “conjugate offset surfaces of equal distance” has been applied into this field. First, suppose that there is a surface of second order, the coefficients of which are arbitrary. Then find out the best posture of the circle in order that the circle and the surface will most closely contact with each other at the origin position. Finally, develop the surface into a 3-order surface at every point of machining and employ the results mentioned above to find the best cutter posture at every point of machining. Therefore, the equations are easy to solve and clear in concept. This paper showed how to use this method for the machining of a die. This project is supposed by the natural scientific foundation of Zhejiang province, China, No. Y106047 and Y1080093.3.
Keywords
cutting tools; mesh generation; milling; 5-axis end milling machining; China; Zhejiang province; circular cutter; conjugate offset surface; gear meshing theory; natural scientific foundation; scuptrued surface; NC machining; contact; surface;
fLanguage
English
Publisher
ieee
Conference_Titel
Mechanical and Electronics Engineering (ICMEE), 2010 2nd International Conference on
Conference_Location
Kyoto
Print_ISBN
978-1-4244-7479-0
Type
conf
DOI
10.1109/ICMEE.2010.5558456
Filename
5558456
Link To Document