DocumentCode :
227266
Title :
Re-deposition of lithium and boron coatings under high-flux plasma bombardment at normal and grazing magnetic incidence
Author :
Abrams, T. ; Jaworski, M.A. ; Kaita, R. ; Nichols, J.H. ; De Temmerman, G. ; van den Berg, M.A. ; van der Meiden, H.J. ; Morgan, T.W.
Author_Institution :
Princeton Plasma Phys. Lab., Princeton, NJ, USA
fYear :
2014
fDate :
25-29 May 2014
Firstpage :
1
Lastpage :
1
Abstract :
Summary form only given. Thin coatings composed of low-Z elements (lithium, boron, beryllium, carbon) are applied to graphite or metal substrates in tokamaks. Because these coatings improve plasma performance, it is important to characterize how fast the film thickness changes. The erosion rate of these low-Z elements is strongly dependent on ion flux Γi and surface temperature Tsurf. Re-deposition rates vary with electron temperature Te and density ne. Thus it is crucial to understand the evolution of these films during plasma bombardment at similar ne (> 1019 m-3), Te (<; 15 eV), Γi (> 1023 m-2s-1), Tsurf (<; 800°C), and magnetic geometry found in the divertor. An analytic/numerical model was developed to simulate the mechanisms of particle loss/gain from thin films during plasma bombardment. Predictions of Li erosion rates1 were obtained through empirical extrapolation from existing measurements. The model predicts re-deposition fractions exceeding unity for Li-coated TZM Mo during bombardment at normal magnetic incidence for ne = 1020 m-3 and Te > 1.5 eV. The time evolution of Li and B coatings on graphite and TZM Mo were studied in Magnum-PSI2, a linear plasma device with Γi >1024 m-2s-1 and Te <; 4 eV. A series of 2-7 s plasma exposures at both normal and grazing magnetic incidence were run on bare samples of each substrate and after a deposition of 100-1000 nm of Li or B. Line radiation was monitored using a camera with an optical filter. Parameter scans were performed in Tsurf (250-1000°C), Te (0.5-4.0 eV) and ne (0.7-4.0*1020 m-3). Measurements of the Li erosion rate on TZM Mo at normal - ncidence were significantly lower than predictions from the empirical formula1. A mechanism involving chemical interactions between Li and D was hypothesized. Results from exposures of Li-coated TZM to neon plasmas will be discussed. Initial observations indicate Li redeposition fractions between 0.9 and 0.98. Further measurements of Li and B re-deposition fractions at normal and grazing incidence will be reported.
Keywords :
Tokamak devices; boron; electron density; extrapolation; lithium; metallic thin films; plasma density; plasma deposited coatings; plasma deposition; plasma simulation; plasma temperature; plasma toroidal confinement; B; B redeposition fraction measurement; C; Li; Li erosion rate predictions; Li redeposition fraction measurement; Li-coated TZM Mo; Magnum-PSI; Mo; analytic-numerical model; boron coating redeposition; chemical interactions; divertor; electron density; electron temperature; electron volt energy 0.5 eV to 4 eV; empirical extrapolation; film evolution; film thickness; graphite substrate; grazing magnetic incidence; high-flux plasma bombardment; ion flux; line radiation; linear plasma device; lithium coating redeposition; low-Z elements; magnetic geometry; metal substrate; neon plasmas; normal magnetic incidence; optical filter; parameter scans; particle gain mechanism; particle loss mechanism; plasma exposures; plasma performance; redeposition rates; size 100 nm to 1000 nm; surface temperature; temperature 250 degC to 1000 degC; thin coatings; time evolution; tokamaks; Boron; Coatings; Lithium; Magnetic flux; Plasma measurements; Plasmas;
fLanguage :
English
Publisher :
ieee
Conference_Titel :
Plasma Sciences (ICOPS) held with 2014 IEEE International Conference on High-Power Particle Beams (BEAMS), 2014 IEEE 41st International Conference on
Conference_Location :
Washington, DC
Print_ISBN :
978-1-4799-2711-1
Type :
conf
DOI :
10.1109/PLASMA.2014.7012276
Filename :
7012276
Link To Document :
بازگشت