DocumentCode
2870923
Title
A Method of Digital to Shaft-Angle Converting Using ARM Series MCU & CPLD
Author
Xiangtong Kong ; Chunping Wang ; Shuying Sun ; Fei Gao
Author_Institution
Dept. of Opt. & Electron. Eng., Ordnance Eng. Coll., Shijiazhuang, China
Volume
2
fYear
2012
fDate
28-29 Oct. 2012
Firstpage
262
Lastpage
265
Abstract
A new DSC system that based on the STM32F4 MCU and CPLD is designed in this paper, the STM32F4 mainly takes on the data operation, and the CPLD generate the PWM signals based on the data calculated by the MCU part. the duty cycle of the PWM signal is computed baed on the input Shaft-angle, after calculation and the PWM signal´s production, the Full-bridge will be controlled to creat the modulation. then the synchronous motor will be drived by the drive wave to work. the sine part of the modulate wave is calculated by checking the tables saving the sine value, so the operation is simple and get a better real-time performance. above all, this method has the advantages of great efficiency, lower heat and cheap cost over others and it has been successfully used in the antiaircraft gun servo control system. It also provides a new method for other DSC systems.
Keywords
aircraft control; bridge circuits; microcontrollers; real-time systems; servomechanisms; synchronous motors; ARM series MCU; CPLD; DSC system; PWM signal production; STM32F4 MCU; antiaircraft gun servo control system; data calculation; digital-to-shaft-angle conversion; duty cycle; real-time performance; sine value; synchronous motor; wave modulation; Frequency modulation; Hardware; Pulse width modulation; Real-time systems; Shafts; Synchronous machines; CPLD; DSC; Full-bridge driver; Look-up table method; PWM modulation; STM32F4;
fLanguage
English
Publisher
ieee
Conference_Titel
Computational Intelligence and Design (ISCID), 2012 Fifth International Symposium on
Conference_Location
Hangzhou
Print_ISBN
978-1-4673-2646-9
Type
conf
DOI
10.1109/ISCID.2012.217
Filename
6405546
Link To Document