DocumentCode
3339071
Title
Notice of Retraction
Preparation and Effect on the Coal Slime Water of Poly-Ferric-Aluminum-Silicate-Sulfate
Author
Xingjian Ren ; Jianwei Li ; Pan Ran ; Wei Du ; Mei Jia ; Caifeng Zhang ; Wenjie Zhou
Author_Institution
Coll. of Chem. & Chem. Eng., Xi´an Univ. of Sci. & Technol., Xi´an, China
fYear
2011
fDate
10-12 May 2011
Firstpage
1
Lastpage
3
Abstract
Notice of Retraction
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
Poly-ferric-aluminum-silicate-sulfate was synthesized by using sodium silicate, ferric sulfate and aluminum sulfate as materials. With single factor analysis and orthogonal experiment, the optimum coagulation parameters of PFASS have also been discussed. The results indicated that the best parameters were molar ratio (Al + Fe)/Si 1.2, reaction temperature 60°C, reaction time 10 min, dosage of poly-ferric-aluminum-silicate-sulfate 20 mg/L, the best flocculation results can be achieved (the removal rate of turbidity to coal slime water was up to 96.2%) under these conditions.
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
Poly-ferric-aluminum-silicate-sulfate was synthesized by using sodium silicate, ferric sulfate and aluminum sulfate as materials. With single factor analysis and orthogonal experiment, the optimum coagulation parameters of PFASS have also been discussed. The results indicated that the best parameters were molar ratio (Al + Fe)/Si 1.2, reaction temperature 60°C, reaction time 10 min, dosage of poly-ferric-aluminum-silicate-sulfate 20 mg/L, the best flocculation results can be achieved (the removal rate of turbidity to coal slime water was up to 96.2%) under these conditions.
Keywords
aluminium compounds; chemical engineering; chemical reactions; coagulation; coal; industrial waste; sodium compounds; wastewater treatment; coal slime water; flocculation; molar ratio; optimum coagulation parameters; poly-ferric-aluminum-silicate-sulfate; reaction temperature; single factor analysis; sodium silicate; temperature 60 degC; Aluminum; Coagulation; Coal; Iron; Plastics; Silicon;
fLanguage
English
Publisher
ieee
Conference_Titel
Bioinformatics and Biomedical Engineering, (iCBBE) 2011 5th International Conference on
Conference_Location
Wuhan
ISSN
2151-7614
Print_ISBN
978-1-4244-5088-6
Type
conf
DOI
10.1109/icbbe.2011.5781178
Filename
5781178
Link To Document