DocumentCode
3487464
Title
Effects of coupling sleeve designs on an RF charged plasma monopole antenna
Author
Halili, N.A. ; Ali, M.T. ; Zali, H.M. ; Ja´afar, H. ; Pasya, Idnin ; Dagang, A.N.
Author_Institution
Antenna Res. Center (ARC), Univ. Teknol. MARA (UiTM), Shah Alam, Malaysia
fYear
2013
fDate
9-11 Dec. 2013
Firstpage
467
Lastpage
470
Abstract
This paper presents an analysis of monopole plasma antenna performance using different number of turns of coil (as coupling sleeve). The plasma antennas were fabricated with 3 different gases which are neon, argon and xenon with pressure 0.5 Torr, 5 Torr and 15 Torr. The dimension of each tube is 130 mm length and 10 mm diameter. The plasma antennas were driven by radio frequency (RF) to sufficiently ionize the gas inside the tube to convert them into plasma state. Each antenna with different configuration of type of gas and pressure was tested while varying the number of coils turns. The antenna´s capability to operate as transceiver was verified through measurement of receiving signal power using a spectrum analyzer. It was found that 4 turns of the coil was optimum in each configuration.
Keywords
argon; coils; ionisation; monopole antennas; neon; spectral analysers; transceivers; xenon; Ar; Ne; RF charged plasma monopole antenna; Xe; coupling sleeve designs; plasma state; radio frequency; signal power; spectrum analyzer; Antenna measurements; Coils; Electron tubes; Microwave antennas; Plasmas; Radio frequency; Plasma antenna; RF signal source; argon; copper coil; neon; number of turns; pressure; xenon;
fLanguage
English
Publisher
ieee
Conference_Titel
RF and Microwave Conference (RFM), 2013 IEEE International
Conference_Location
Penang
Print_ISBN
978-1-4799-2213-0
Type
conf
DOI
10.1109/RFM.2013.6757308
Filename
6757308
Link To Document