DocumentCode
518374
Title
Notice of Retraction
Process optimization for isothermal forging of TiAl compressor blade by numerical simulation
Author
Zhang, H. ; Zong, Y.Y. ; Xu, W.C. ; Shan, D.B.
Author_Institution
Dept. of Mater. Sci. & Eng., Harbin Inst. of Technol., Harbin, China
Volume
5
fYear
2010
fDate
16-18 April 2010
Abstract
Notice of Retraction
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
The isothermal forging process of TiAl compressor blade was optimized by numerical simulation. The results show that the forging defect can be eliminated by modifying preform dimension. In addition, the offsetting force can be reduced by optimizing the shape of preform. Friction condition has obvious effect on the forging load and the reasonable friction coefficient is in the range of 0~0.04. The reasonable thickness of flash is 1mm for the TiAl blade. Actual forging experiment was carried out based on the optimized process. TiAl compressor blade without defects was achieved and good mechanical properties can be achieved due to obvious refinement of the microstructure.
After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE´s Publication Principles.
We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper.
The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org.
The isothermal forging process of TiAl compressor blade was optimized by numerical simulation. The results show that the forging defect can be eliminated by modifying preform dimension. In addition, the offsetting force can be reduced by optimizing the shape of preform. Friction condition has obvious effect on the forging load and the reasonable friction coefficient is in the range of 0~0.04. The reasonable thickness of flash is 1mm for the TiAl blade. Actual forging experiment was carried out based on the optimized process. TiAl compressor blade without defects was achieved and good mechanical properties can be achieved due to obvious refinement of the microstructure.
Keywords
blades; compressors; forging; friction; numerical analysis; optimisation; titanium compounds; TiAl; compressor blade; forging defect; friction coefficient; isothermal forging; numerical simulation; offsetting force; process optimization; Blades; Engines; Friction; Isothermal processes; Materials science and technology; Mechanical factors; Numerical simulation; Preforms; Shape control; Shape memory alloys; TiAl; isothermal forming; numerrical simulation;
fLanguage
English
Publisher
ieee
Conference_Titel
Computer Engineering and Technology (ICCET), 2010 2nd International Conference on
Conference_Location
Chengdu
Print_ISBN
978-1-4244-6347-3
Type
conf
DOI
10.1109/ICCET.2010.5486100
Filename
5486100
Link To Document