Scaling controllable adhesives to grapple floating objects in space

As the number of rocket bodies and other debris in Earth´s orbit increases, the need to capture and remove this space junk becomes essential to protect new satellites. A low cost solution may include gecko-inspired directional adhesives, which require almost no compressive preload to generate adhesion and are therefore suitable for surface grasping in space where objects are free floating. Current individual adhesive units with a pair of opposed pads achieve a limit of 13N normal to the surface. Instead of using a single large unit to generate high levels of adhesion, using multiple small gripper units is desirable to prevent single-point failures and to conform to higher curvatures. For this strategy to succeed, it is essential to distribute the overall force evenly, to minimize the overall preload normal to the surface, and to prevent local failures from propagating over the array. We present two load sharing mechanisms. The first uses nearly-constant force springs in parallel. The second uses a tendon and pulleys in series. Both allow a 4-unit gripper to maintain the same adhesive stress as a single unit. A normal adhesive load to compressive preload ratio of 100:1 is demonstrated. Zero gravity experiments and air bearing floor experiments demonstrate the gripper´s functionality in a simulated space environment. Design considerations are discussed for further scaling, with the trade-offs among load sharing, suitability for different surfaces, and failure sensitivity.