DocumentCode
755135
Title
Low-power flyback converter with synchronous rectification for a system with AC power distribution
Author
Fernández, Arturo ; Sebastián, Javier ; Villegas, Pedro José ; Hernando, Marta M. ; Barcia, Lourdes Álvarez
Author_Institution
Grupo de Electronica Ind., Oviedo Univ., Gijon, Spain
Volume
49
Issue
3
fYear
2002
fDate
6/1/2002 12:00:00 AM
Firstpage
598
Lastpage
606
Abstract
IEC 1000-3-2 regulations impose a reduced harmonic content on any converter with an input power higher than 75 W. However, if the power architecture of the system is based on small on-board converters, and the total power is higher than 75 W, IEC regulations must be fulfilled although each individual converter need not comply with the regulations. In this paper, one of the different possible solutions is presented. Each on-board converter has an active input current shaper (AICS) in order to reduce the input current harmonic content of each converter and, hence, to comply with IEC 1000-3-2 regulations. Moreover, two different types of AICSs were compared: the conventional one and a new type of AICS based on a full-wave rectifier
Keywords
AC-DC power convertors; DC-DC power convertors; IEC standards; harmonic distortion; harmonics suppression; power conversion harmonics; power factor correction; rectifying circuits; 75 W; AC power distribution; IEC 1000-3-2 regulations; active input current shaper; distributed power systems; harmonic content reduction; low-power flyback converter; on-board converters; power architecture; synchronous rectification; DC-DC power converters; Europe; IEC standards; Internet; Pollution; Power distribution; Power electronics; Power system harmonics; Rectifiers; Resistors;
fLanguage
English
Journal_Title
Industrial Electronics, IEEE Transactions on
Publisher
ieee
ISSN
0278-0046
Type
jour
DOI
10.1109/TIE.2002.1005386
Filename
1005386
Link To Document