Design of a Facility for Measuring Scintillator Non-Proportionality

While the original Compton coincidence technique provided accurate measurements of electron response in scintillators, the data rate was low and measurements took weeks. We present the conceptual design for a high throughput version that is predicted to collect data at 65 cps, reducing measurement times from weeks to hours. In this design, a collimated 1 mCi ¹³⁷Cs source will illuminate the scintillator sample from a distance of 18 cm and 5 high-purity germanium (HPGe) detectors placed 10 cm from the scintillator will measure the energy of the scattered gamma ray. The source can be placed in either of two positions spaced 15deg apart, allowing relatively uniform scattering angle coverage from 0deg to 146deg, corresponding to electron energies in the scintillator from 0 to 466 keV. The scintillator will be coupled to a hybrid photodetector (HPD), which has extremely linear response, and the HPD´s ability to resolve single photoelectrons provides a built-in calibration mechanism. The output of each HPGe detector and the HPD will be digitized with a free-running 12-bit, 200 MHz ADC, providing accurate measurement of the signal amplitudes and the ability to measure the electron response for different temporal components of the scintillator signals. The facility will be located at Lawrence Livermore National Laboratory (LLNL) and is intended to be made available to the community at large. The goals are to facilitate scintillator development and to understand the nature of the light-yield non-proportionality and its effect on the energy resolution.