Photoresist deposition without spinning

A technique for resist deposition using a novel fluid ejection method is presented in this paper. An ejector has been developed to deposit photoresist on silicon wafers without spinning. Drop-on-demand coating of the wafer reduces waste and the cost of coating wafers. Shipley 1400-21, 1400-27, 1805, and 1813 resists were used to coat sample 3- and 4-in wafers. Later, these wafers were exposed and developed. The deposited resist film was 3.5 μm thick and had a surface roughness of about 0.2 μm. The ultimate goal is to deposit resist films with a thickness of the order of 0.5 μm and a surface roughness of the order of 30 Å, which is currently achieved for 200-mm silicon wafers by using a spinning method. Such goals can be attained by using micromachined multiple ejectors or with better control over the deposition environment. In the micromachined configuration, thousands of ejectors are made into a silicon die, as presented by Percin et al. (2002), and thus allow for a full coating of a wafer in a few seconds. Coating in a clean environment will allow the lithography of circuits for microelectronic applications. Other potential applications for the technology in the semiconductor manufacturing are in deposition of low-k materials, wafer cleaning, manufacturing of organic LEDs and organic FETs, direct lithography, nanolithography, and coating for hard-disk drives.