Fabrication and Testing of a High-Speed Microscale Turbocharger

A microelectromechanical system (MEMS) turbocharger has been designed, fabricated, and tested as part of a Massachusetts Institute of Technology program aimed at producing a microfabricated gas turbine engine for portable power applications. A gas turbine engine requires high-speed high-efficiency turbomachinery operating at tip speeds of several hundred meters per second. This MEMS turbocharger serves to demonstrate these requirements. The turbocharger´s silicon rotor, which is supported on hydrostatic gas thrust and journal bearings in a silicon stator housing, was spun to 480 000 rpm, corresponding to a tip speed of 200 m/s. This paper discusses critical fabrication processes that enabled the capabilities of this device. Operational issues and test results are also presented. The turbocharger´s compressor demonstrated a pressure ratio of 1.21 at a mass flow rate of 0.13 g/s, with a combined compressor-turbine spool efficiency of 0.24. Under these conditions, the turbine produced about 5 W of power. Results from the simultaneous operation of a spinning rotor and burning combustor within the microscale turbocharger are also presented. Experimental results compare well with analytical models and computations.