6-bit 500 MHz flash A/D converter with new design techniques

The authors present a 6-bit 500 Msample/s CMOS flash analogue-to-digital converter (ADC) with new design techniques. A technique referred to as the new autozeroing with interpolation (NAI) technique is proposed to include both autozeroing without idle time and interpolation operations at the same time in this high-speed low-latency flash ADC. A switching preamplifier is used in NAI to avoid using non-overlapped control signals required by conventional autozeroing ADCs and to eliminate the interference, caused by the high-speed autozeroing operation, at input nodes. Also, NAI has the benefit of a single-phase control to avoid synchronisation problems since multiphase clock signals are necessary for flash ADCs with autozeroing. While charge injection and feedthrough in NAI limit the ADC performance, a capacitor averaging technique is incorporated with NAI to decrease these errors. A negative impedance compensation technique is used to overcome the speed limitation of interpolation operations so that the ADC can operate at a high sampling rate. The designed ADC is fabricated in 0.25 μm 1P5M CMOS technology and occupies an active area of 0.3 mm². The measurement results show that the design can achieve a sampling rate of 500 MHz with a SNR>30 dB. The total chip draws 261 mW from a 2.5 V power supply